Panasonic KX-TD500 System Reference Manual page 600

8.00 Operator Call
Description
Allows the extension users to call the operator by
dialing the feature number for "Operator Call
(General)" or "Operator Call (Specific)".
Up to two operators are assignable for the whole
system. If Tenant Service is available, two
operators are assignable for each tenant, that
makes four operators available for the whole
system.
If two operators are assigned in the system, or in
a tenant (if tenant Service is employed),
extension users can specify the operator (in the
same tenant) by dialing the feature number for
"Operator Call (Specific)".
Programming
System Programming
"System-Numbering Plan (2/11)",
Operator Call (General)
Operator Call (Specific)
Conditions
When calling an operator by dialing the feature
number for "Operator Call (General)", the
operator is selected according to the type of the
operator's stations as shown below:
Type of Station
Operator 1 Operator 2
ATT ATT
ATT EXT
EXT EXT
ATT —
EXT —
* The call which is made by the "Operator
Call (General)" arrives alternately to each
attendant console.
When no operators are assigned, a user hears
reorder tone during executing Operator Call.
For the assignment of operators, refer to Section
3-B-5.00 "Operator".
Reference
VT Dumb
10-D-6.02 11-C-11.00
Operator
Selected
Operator 1 or
*
Operator 2
Operator 1 only
Operator 1 only
Operator 1 only
Operator 1 only
5-A-20
Operation
Calling an operator
1. Lift the handset.
2. Calling an operator without
specifying
1) Dial the feature number for
"Operator Call (General)"
(Default : 0).
Calling an operator by specifying
1) Dial the feature number for
"Operator Call (Specific)"
(Default : none).
2) Dial "1" to specify operator 1.
Dial "2" to specify operator 2.