Master Cylinder; Inspection Of Brake Disc - Honda 2010 CBX 250 Workshop Manual

HYDRAULIC BRAKE
Install the clip of the brake in the fork left, so that the disc
brake is located between the pads.
NOTE
Be careful not to damage the pads.
Install and tighten the new fixing bolts the clip of the brake.
TORQUE VALUE: 26 N.m (2,6 kg.m)
Tighten the smugglers of pads.
TORQUE VALUE: 18 N.m (1,8 kg.m)
Install and tighten the caps of the smugglers of pads.
TORQUE VALUE: 2 N.m (0,2 kg.m)
Activates the brake for the pistons of the clamp to settle in
the pads.

INSPECTION OF BRAKE DISC

Visually inspect the disk with regard to damage or cracks.
Measure the thickness of the disc brake on various points,
using a micrometer.
Service Limit
Replace the disc brake in case of the lower measurement is
below the limit of service. Measure twist of the disc brake,
using an indicator of quadrant.
Service Limit
In the event that twist exceed the limit of service, inspect
the bearings of the wheel with regard to slack excessive.
In the event that the bearings are normal, replace the disc
brake.

MASTER CYLINDER

DISMANTLING
Remove the support of the cylinder master (page 13-3). Drain
the fluid in the system of hydraulic brake (page 15-3).
Disconnect the hose the brake, removing the bolt banjo, the
washers in sealing and the connection of the hose.
i
•Avoid shed fluid brake on painted surfaces,
surfaces of plastic or in parts of rubber. Place a
cloth on these parts, to make services in the
brake system.
•To remove the bolt banjo, tape the tip of the
hose, to avoid the pollution.
Remove the bolts of support from the cylinder master. Then,
remove the whole of the cylinder master (page 12-4).
15-6
FIXING BOLTS THE CLIP OF THE brake
3,5 mm
0,1 mm
SEALING WASHERS
PASADORES DE TAPONES DE LOS PASADORES
LAS PASTILLAS DE LAS PASTILLAS
BOLT Connecting
CBX250
the Hose