Inspection Of The Ignition System; Voltage Peak Winder Primary Of The Ignition Coil - Honda 2010 CBX 250 Workshop Manual

IGNITION SYSTEM
INSPECTION OF THE IGNI-
TION SYSTEM
NOTE
•If there is no sparks in the spark plug, check all
connections with regard to contacts loose or
inadequate, before measuring the voltage of peak.
•Use a digital multitester recommended, commer-
cially available, with a minimum impedance of 10
M /Vcc. •The values presented differ, according to
the memory of multitester.
•If using a tester diagnostic Imrie (model 625),
follow the manufacturer's instructions.
Connect the adapter from the voltage of peak in the
multitester or use the tester diagnostic Imrie.
Tools:
ADAPTER FROM THE VOLTAGE OF PEAK 07HGJ-0020100
With a digital multitester commercially available
(impedance minimal 10 MΩ/Vcc).
VOLTAGE PEAK WINDER PRIMARY OF THE IGNI-
TION COIL
NOTE
•Check all connections of the system, before the
inspection. Inadequate Connections can result in
incorrect readings. •Verify the compression of the
cylinder. Check if the spark plug is properly
installed.
Remove the plate pit side right (page 2-3).
Place the transmission in neutral and disconnect the
noise dampening layer of the spark plug.
Connect a spark plugof turning in good condition at the noise
dampening layer and make the connection to the earth of
the spark plugin the cylinder head, as in the proof of spark.
17-4
Tester Imrie (model 625) o
ADAPTER FROM THE VOLTAGE OF PEAK
SPARK PLUGOF TURNING in good condition
CBX250
MULTITESTER DIGITAL
(IMPEDANCIA MÍNIMA
DE 10 MΩ/VCC)