Assembly Of The Casing Of The Engine - Honda 2010 CBX 250 Workshop Manual

CBX250
Install the rings of pressure, the spring of return and the
spring of replenishment in spindle gearbox, according to the
illustration.
Lubricate the checkpoint of oil spindle of gears with engine
oil.
Install the spindle gearbox aligning the ends of the spring of
return with the bolt spike, while holding off the plate selector
gears.

ASSEMBLY OF THE CASING OF THE ENGINE

Clean completely the contact surfaces of the halves
right and left to the casing of the engine, taking care
not to damaging them.
Inspect the contact surfaces with regard to damage.
Install the ears of guide and a gasket new on the left half
of the casing of the engine.
Be sure to have installed correctly all parts of the halves right
and left to the casing of the engine.
i
Do not force the halves of the casing of the engine. If
you need excessive force to install is because there is a
flaw in the assembly. Remove the right half of the housing
and please check with respect to spare poorly aligned.
Install half right on the left half of the casing of the
engine.
RETURN SPRING
PLATE SE-
LECTOR
GEARS
OIL SEAL
GUIDE SPIKE
RIGHT HALF OF THE CASING OF THE ENGINE
TRANSMISSION
RING OF PRESSURE
BOLT Spike
RETURN SPRING
NUEVA
GASKET