Master Cylinder - Honda NX250 1989 Manuals

HYDRAULIC BRAKE

MASTER CYLINDER

DISASSEMBLY
Drain brake fluid from the hydraulic system (page 14-3).
CAUTION
* Avoid spilling fluid on painted, plastic, or rubber parts. Placea
rag over these parts whenever the system is serviced.
Remove the rear view mirror.
Loosen the brake hose joint nut and disconnect the brake hose
from the joint.
Disconnect the front brake light switch wires.
Remove the master cylinder.
CAUTION
• When removing the brake hose cover the end of the hose to pre-
vent contamination.
Remove the brake lever by removing the pivot nut and bolt.
Remove the brake light switch by removing the screw.
Remove the piston boot.
Remove the snap ring from the master cylinder.
TOOL:
Snap ring pliers
Remove the following:
— washer
— master piston
— spring
Clean the master cylinder, reservoir and master piston in clean
brake fulid.
14-6
0 7 9 1 4 - 3 2 3 0 0 0 1 or
equivalent commercially
available in U.S.A.
PLIERS