Axle; Eccentricity Of The Rim Of The Wheel - Honda 2010 CBX 250 Workshop Manual

CBX250
Remove the gear box of the speedometer of the left side of
the body of the wheel.
INSPECTION

Axle

Support for the front axle on two blocks in V . Turn the front
axle and measuring its twist, using an indicator of quadrant.
Consider the half of the total reading of the indicator of
quadrant as the real twist.
Ball the wheel
Service Limit
Turn the internal track of each bearing the finger. The bear-
ings must be turning smoothly and without noise. Make
sure that the track outside of each ball is firmly embedded
in the body. In case of the track of some bearing no gently
turn and without noise, or do not fit firmly within the hub,
remove and discard the bearing.
NOTE
Lubricate los new bearings con grasa. Instálelos en el body,
Replace the bearings of the wheel to pairs.
utilised las tools special (page 13-12).

Eccentricity of the rim of the wheel

Place the wheel in a revolving support and verify the
eccentricity of the rim. Turn the wheel manually and
slowly. Read the eccentricity with an indicator of
quadrant. Consider the half of the total reading of the
indicator of quadrant as eccentricity real.
Radial
Service
Limit
Axial
FRONT WHEEL/SUSPENSION/STEERING
0,20 mm
2,0 mm
2,0 mm
Gear Box OF THE SPEEDOMETER
BALL THE WHEEL
AXLE