CBX250
REAR FENDERS
DISMANTLING
Remove the tail piece (page 2-2).
Disconnect the connector of the rear /
light of brake. Remove the three nuts,
washers and the connector of the rear / light
of brake. Disconnect the connectors of
the indicator rear. Remove
the four bolts. Remove the rear fenders
of the chassis.
DISMANTLING/INSTALLATION
Remove the two nuts, support, and the indicator rear. The
installation and the assembly carried out in reverse order
dismantling.
PLATE SIDE PIT
DISMANTLING/Installation
Remove the four screws of the plates baffles side. Remove
the plates baffles side.
NOTE
Be careful not to damage the plates baffles side
during the dismantling / installation.
To installation is performed in reverse order dismantling.
Chassis/FAIRING/EXHAUST SYSTEM
NUT/WASHER
REAR INDICATOR
BOLT
BRACKET
BOLT
PLATE SIDE PIT
CONNECTOR
REAR / LIGHT
OF brake
REAR FENDERS
NUTS