Brake Clamp - Honda 2010 CBX 250 Workshop Manual

HYDRAULIC BRAKE
Install the switch of the light of front brake cylinder
master, aligning the highlight the switch and the hole
in the master cylinder.
Install and tighten the screw breaker of the light of front
brake.
TORQUE VALUE: 1 N.m (0,1 kg.m)
Place the whole of master cylinder on the handlebars
(page 13-5).
Install the connection of the hose of brake cylinder
master, with the bolt banjo and the new washers of seal.
Press the hose of the brake against the limiter on the mas-
ter cylinder. Then, tighten the bolt banjo to value specified.
TORQUE VALUE: 34 N.m (3,4 kg.m)
Plug the connectors breaker of the light of front brake (page
13-5).
Install the rearview mirror (page 13-8).
Supplying the deposit toward the mark of a higher level
and carry out the purge of air of the hydraulic system of
front brake (page 15-3).

BRAKE CLAMP

i
Avoid shed fluid brake in painted surfaces, surfaces of
plastic or in parts of rubber. Place a cloth on these parts,
to make services in the brake system.
DISMANTLING
Drain the fluid in the hydraulic system of front brake
(page 15-3).
Disconnect the hose of the brake of the clamp front
brake, removing the bolt of connection, the washers in
sealing and the connection of the hose.
Remove the fixing bolts the pliers and the pads of the
brake (page 15-4).
15-10
Align
PARAFUSO
SEALING WASHERS
NUEVA
LIMITER HOSE
BOLT BANJO
SEALING WASHERS
CBX250
SWITCH
Align
SWITCH
BOLT BANJO
FIXING
BOLTS