LIGHTS/INDICATORS/SWITCHES
Check to see if there is a continuity between the terminals of
the connectors of the ignition switch, in all the positions. The
continuity must obey the c code that occurs in the table
below:
IGNITION SWITCH
R
BI
Activated
O
O
Deactivated
Lock
DISMANTLING/Installation
Remove the higher bridge (page 13 -22).
Release the connectors of the ignition switch.
Remove the two fixing bolts and the power switch.
Install the power switch and tighten the fixing bolts.
Install the parts removed.
SWITCHES OF THE HANDLEBARS
NOTE
Refer to page 13-3 to obtain information to respect the
dismantling / installation of the switches of the
handlebars.
Remove the connector of the light (page 19-4). Check if there is a
continuity between the terminals connector, in all the
positions of switch, according to the c code that
occurs in the tables below:
SWITCHES ON THE RIGHT SIDE OF THE
HANDLEBARS
Release the connector 9P of the switches on the right side of
the handlebars.
EMERGENCY SWITCH
BI/R BI/W
Deactivated
Run (Activated)
O
O
STARTER SWITCH
BI/W
Y/R
Free
Pressed
O
O
19-10
BOLTS
CONNECTOR 9P OF THE
SWITCHES ON THE RIGHT
SIDE OF THE HANDLEBARS
CBX250
IGNITION
SWITCH
CONNECTOR 9P
SWITCHES ON THE
RIGHT SIDE OF THE
HANDLEBARS