Operation Of The Accelerator - Honda 2010 CBX 250 Workshop Manual

CBX250

OPERATION OF THE ACCELERATOR

Check the cables of the accelerator and replace in the event
that they are damaged, bent or damaged. Check if the grip of
the accelerator operates smoothly. Check if the same returns
in a complete and automatic, since the full open position, in
all the positions of the handlebars. If the handgrip fails to
return in an appropriate manner, lubricate the cables accel-
erator, dismantle and inspect the support of the accelerator.
Procedure for lubrication of the cable: Disconnect the upper
extremities of the cables accelerator. Lubricate totally the
cables and their points of articulation with a lubricant of cabos
commercially available or an oil of low viscosity. If the grip
still fails to return properly, replace the cables accelerator.
d
The use of cables bent, damaged or twisted so abnor-
mal can harm the operation of the accelerator and
cause the loss of control during the conduct of the
motorcycle.
With the engine idling, turn the handlebars completely to the
right and left, to ensure that the idle does not alter.
Idle speed: 1.400 ± 100 rpm
In the event that the rotations of idle increase, check the free
play of the grip of the accelerator and the cable connections.
Measure the play free in the flange of the grip of the
accelerator.
Free play: 2 – 6 mm
The play free of the grip can be set in the adjuster the
support of the accelerator. If necessary, loosen against and
turn the adjuster for the play free. Check again the
functioning of the accelerator. Replace any piece dam-
aged, if necessary. After adjustment, tighten the firmly.
MAINTENANCE
ADJUSTER
LOCKNUT