Honda 2010 CBX 250 Workshop Manual page 199

FRONT WHEEL/SUSPENSION/STEERING
Install the support of the casing of the headlight and the
higher bridge.
NOTE
Guide correctly the cables and wiring.
Install the washer and nut of the steering column. Install
temporarily the forks. Using the special tool, tighten the
nut of the steering column to the specified torque.
TORQUE: 103 N.m (10,3 kg.m)
Tools:
Key socket of the steering
column, 30 x 32 mm
Install the lid of the nut of the steering column.
Install the following components:
Table of instruments (page 19-6)
Casing for the light (page 19-4)
Handlebars (page 13-5)
Forks front (page 13-21)
BURDEN AFTER THE BALL THE steering column
Support for the motorcycle in a proper support and to lift
the front wheel of the soil. Locate the steering column in a
position reta, forward. Insert a dynamometer in the tube of
the fork, between the bridges lower and upper.
NOTE
Make sure that there is no interference of cables,
cabled or hoses.
Position the dynamometer, keeping it in angle with
the steering column. The readings of the scale from
the point where the steering column begins to move.
Burden after the ball the steering column:
0,98 – 1,47 N (0,10 – 0,15 kgf)
In the event that the reading does not obey the limit of
service, to support the front wheel on the ground and ad-
justment again the adjustment nut of the steering column.
The installation is performed in reverse order dismantling.
13-28
07716-0020400
CBX250