Installing The Sprocket Of Transmission - Honda 2010 CBX 250 Workshop Manual

CBX250
INSTALLATION
NOTE
•Locate the cat of flat or other support adjustable below
the engine. •Must be adjusted continually the height
of the cat of flat, with the aim to alleviate the
pressure and facilitate the installation of the bolts.
Place the engine in the chassis. Install, without squeezing,
all the bolts, nuts and plates of fixing. Tighten all the nuts
and bolts to the specified torque.
TORQUE:
1. Bolt / nut lower rear engine
2. Bolt / nut higher rear engine
3. Bolts / nuts from rear support
higher engine
4. Bolt / nut superior engine
5. Bolts / nuts and bolts of upper stand
of the engine
6. Bolt / nut lower front engine
7. Bolt / nut striker higher from the
engine
8. Bolts / nuts from support striker su-
perior of the engine
Installing the SPROCKET OF
TRANSMISSION
Install the sprocket of transmission in the countershaft.
Install the drive chain in the sprocket of transmission.
Install the plate of fixing the pinion, according to the illustration.
Install and tighten bolts of the plate of fixing the sprocket
of transmission to the specified torque.
TORQUE: 10 N.m (1,0 kg.m)
44 N.m (4,4 kg.m)
44 N.m (4,4 kg.m)
26 N.m (2,6 kg.m)
44 N.m (4,4 kg.m)
26 N.m (2,6 kg.m)
44 N.m (4,4 kg.m)
44 N.m (4,4 kg.m)
26 N.m (2,6 kg.m)
DISMANTLING AND INSTALLING THE ENGINE
5
8
7
6
CHAIN
FIXING BOLTS PLATE
4
2
3
1
FIXING PLATE
SPROCKET