Honda 2010 CBX 250 Workshop Manual page 81

FUEL SYSTEM
Setting the support of the adjusters the wires in the correct
position, according to the illustration. Tighten the two screws.
VACUUM CHAMBER
Install the needle into the piston vacuum. Install the
spring in support of the needle. Position the support of
the needle into the piston vacuum.
Turn the support of the needle clockwise, while pressing
it, until it is locked.
After the giro, make sure that flanges of support and slots
in the piston are well fitted.
Install the diaphragm / piston vacuum in the body of the car-
buretor. Raise of the lower part of piston with your
finger to adjust the tab of the diaphragm notching the body
of the carburetor. Then, install the compression spring and
the lid of the vacuum chamber. Be careful not to damage the
spring.
i
Be careful not to hold the diaphragm below the top of
the vacuum chamber.
5-12
SUPPORTS FOR
SCREWS THE ADJUSTOR CABLES
DIAPHRAGM PISTON/VACUUM
SUPPORT FOR NEEDLE
SUPPORT FOR NEEDLE
COMPRESSION SPRING
DIAPHRAGM PISTON/VACUUM
CBX250
NEEDLE
SPRING
LID
Align