Changing The Fluid Brake/Purge Of The Air; Drainage Brake Fluid; Addition Of Fluid Brake - Honda 2010 CBX 250 Workshop Manual

CBX250
CHANGING THE FLUID BRAKE/PURGE
OF THE AIR

DRAINAGE BRAKE FLUID

i
•To supply, do not allow pollutants (dirt, water, etc. )
entering the deposit open. •Avoid shed fluid brake on
painted surfaces, surfaces of plastic or in parts of
rubber. Place a cloth on these parts, to make services in
the brake system.
Before removing the lid of deposit, turn the handlebars
toward the left, until the deposit left leveled. Remove the
screws, the cover of the deposit, the plate of fixing and the
diaphragm. Connect a hose of plastic in the valve to purge
of the clamp. Loosen the valve of purging and activates the
brake until there is no more flow of fluid through the valve.
Closing the valve to purge.

ADDITION OF FLUID brake

Supplying the deposit with fluid brake DOT 4, retired
from a sealed.
i
Do not mix different types of fluid, as these may
not be incompatible.
Install a system of purge, commercially available, in the valve
to purge. Pump system of purging and loosen the valve to
purge. When lower the level in the deposit, add fluid brake.
NOTE
•Inspect the level of fluid while purge the brake
system, in order to avoid the penetration of air in
the system. •When using a system of purge,
follow the manufacturer's instructions.
Repeat procedures described above, until there is no
more air bubbles in the hose of plastic.
NOTE
•In case that has penetration of air in the system of purge
through the thread of the valve to purge, seal the thread
with tape of Teflon.
•In case of the system of purge is not available, add fluid
brake to the cylinder master and operate the brake for
supplying the system (page 15-4).
Closing the valve to purge. Then, perform the
procedure to purge OF AIR (page 15-4).
HYDRAULIC BRAKE
LEVER OF brake
PURGE VALVE
PURGE
PURGING
VALVE
SYSTEM