Oil Radiator Dismantling; Oil Radiator Inspection - Honda 2010 CBX 250 Workshop Manual

CBX250
LUBRICATION SYSTEM
OIL RADIATOR
FIXING BOLTS/Spacers
BOLTS/TUBES
i
Be careful not to damage the fins of the radiator.
DISMANTLING
Remove the plates baffles side (page 2-3). The drainage of
engine oil (page 3-12). Release bolts and the connections su-
periors of the tubes of oil of the radiator, removing the two
bolts. Remove the fixing bolts the oil cooler and the
OIL RADIATOR
spacers. Then, remove the radiator.
INSPECTION
Inspect the air ducts of oil cooler with regard to obstruction
or damage. Straighten fins using a small screwdriver.
Remove insects, mud or any other type of obstruction, using
compressed air or water to low pressure. In case of the air
flow is restricted in more than 20 percent of the surface of
radiation, replace the radiator. Inspect the radiator and ducts
of oil with regard to leak. Install the spacers and tighten fix-
ing bolts the oil cooler.
FIXING BOLTS/Spacers
OIL RADIATOR
Apply motor oil clean to the new rings o and install in the
SUPERIOR CONNECTION OF THE TUBE OF OIL
connections superiors of the tubes oil radiator. Install and
tighten bolts of the connections of the tubes of oil radiator.
NUEVO
O-RING
4-8