Honda 2010 CBX 250 Workshop Manual page 208

CBX250
Installation of the bearing of the body of the wheel
Apply grease to the cavities of bearing.
i
Never reuse a ball used. Replace provided by a
new one, after remove it.
Using the special tools, install the new bearing on the
left side perpendicular to the wheel, with his side
sealed oriented toward the outside.
Tools
Driver
Accessory, 42 x 47 mm
Pilot, 17 mm
Install the collar side in the body of the wheel. Then, using
the special tools, install the bearing on the right side with
his side sealed oriented toward the outside.
Installation of the bearing of the flange of the crown
Install the collar side of the flange on the new ball the flange
of the crown, using the special tools.
Tools:
Driver
Accessory, 24 x 26 mm
Pilot, 17 mm
Install the bearing and the collar side in the flange of the
crown, using the special tools.
Tools:
Driver
Accessory, 42 x 47 mm
Pilot, 17 mm
Apply grease to lips of the new dust and install in the
flange of the crown.
d
Do not apply grease to drum brakes, because it will
reduce the performance of braking.
07749-0010000
ACCESSORY
07746-0010300
07746-0040400
07749-0010000
07746-0010700
07746-0040400
07749-0010000
07746-0010300
07746-0040400
BEARING/COLLAR SIDE
DUST COVER
REAR WHEEL/BRAKE/SUSPENSION
DRIVER
NUEVO
GRASA
BEARING
SIDE COLLAR
DRIVER
GRASA
NUEVO
ACCESSORY
PILOT
DRIVER
BEARING
NUEVO
PILOT
ACCESSORY
PILOT