Cleaning Of The Carburetor; Parts Of The Carburettor - Honda 2010 CBX 250 Workshop Manual

CBX250
Remove the idle screw, the spring, the washer and the o
ring.
Check the jets with regard to wear or damage. Replace, if
necessary.
Check the idle screw with regard to wear or damage.
Clean the jets with a cleaning solvent and blow out with
compressed air.

CLEANING OF THE CARBURETOR

Remove the following components:
– Diaphragm piston/vacuum
– Main Pump, spray, supplier of needle and supplier
of idling
– Idle screw
– Valve of court of air
i
Never use a piece of wire to clean the air ducts,
because this may damage the body of the carburetor.
Blow all air ducts and fuel in the body of the carburetor with
compressed air.Never use a piece of wire to clean the air ducts,
because this may damage the body of the carburetor.

PARTS OF THE CARBURETTOR

i
Do not remove the sensor accelerator of the body of the carburetor.
TOP OF THE va-
cuum chamber
Compression
SPRING
SUPPORT
FOR THE
NEEDLE
SPRING
NEEDLE
DIAPHRAGM/ PIS-
TON VACUUM
DIAPHRAGM /
VALVE OF
COURT OF AIR
SPRING
SUPPLIER OF
NEEDLE
SUPPLIER OF
IDLING
ATOMIZER
MAIN VALVE
PLATE PIT
BOLT OF
ACCELERATION
BOLT OF FLOAT
FUEL SYSTEM
SUPPLIER
OF
NEEDLE
ATOMIZER
MAIN JET
TOP OF THE
VALVE OF
COURT OF
AIR
NUEVO
SPRING
IDLE SCREW
FLOAT
FLOAT CHAMBER
O-RING
SEAT OF THE
SPRING
SPRING
IDLE
SCREW
IDLING JET
SPRING
CHOKE
VALVE
BODY OF THE
CARBURETORICO
SEAT OF THE SPRING
VALVE IN THE FLOAT
O-RING
NUEVO
DRAINAGE
SCREW
O-RING
NUEVO
5-9