Honda 2010 CBX 250 Workshop Manual page 161

TRANSMISSION
In case of the crankshaft has been removed, install first,
together with the flywheel (page 12-5).
Apply motor oil to the retaining lips oil countershaft.
Install the main axle and the countershaft as a whole, on the
left half of the casing of the engine.
Be sure to install the three washers of the extremities of the
axles (in both legs of the main axle and only in the left
extremity of countershaft).
Each fork of the change of gears possesses an identifica-
tion mark: R for the fork right, C for the fork central and L for
the fork left.
Install each fork of the change of gears in the respective
slot in the gear, with the identification mark oriented toward
above (or: in the direction to the right half of the casing of
the engine).
Apply motor oil in the slots of guide of the drum of gears.
Install the drum, aligning the ears of guide to the forks with
the slots of guide of the drum of gears.
Apply motor oil to the axle of the forks of the change of
gears. Insert through the forks of the change of gears
on the left half of the casing of the engine.
11-10
MAIN AXLE AND COUNTERSHAFT
OIL SEAL
IDENTIFICATION MARKS OF THE FORKS
"R"
"C"
"L"
AXLE OF THE FORKS OF
THE CHANGE OF GEARS
CBX250
DRUM OF gears