Purge Of Air; Disk/Brake Pads - Honda 2010 CBX 250 Workshop Manual

HYDRAULIC BRAKE

PURGE OF AIR

Connect a hose of plastic in the valve to purge of the
clamp. Pump the brake until there is no more air bubbles
in the fluid from the cylinder master, and that the lever
offered resistance.
1. Activates the brake and open the valve purge 1/2 lap.
Then, closing the valve.
NOTE
Do not release the brake until the valve purge has
been closed.
2. Release slowly the brake and wait for a few seconds, until
it reaches the end of its course. Repeat steps 1 and 2 until
there is no more air bubbles in the hose to purge. Tighten
the valve to purge the pair specified.
TORQUE: 5 N.m (0,5 kg.m)
Supplying the deposit toward the mark of the higher level.
Install the diaphragm, the plate of fixing and the
cover of the deposit. Tighten the screws.
TORQUE: 1 N.m (0,1 kg.m)

DISK/brake pads

REPLACEMENT OF THE brake pads
NOTE
Always replace the brake pads to pairs, so that the pres-
sure on the disk is uniform.
Remove the caps of the pins of the pills and release the pins.
Remove the fixing bolts the clip of the brake.
Then, remove the clip of the brake.
15-4
SCREWS
HIGHER
LEVEL
SCREWS
FIXING BOLTS THE CLIP OF THE brake
CAPS OF THE PINS OF THE
CBX250
PURGE VALVE
TOP OF THE
RESERVOIR
FIXING PLATE
DIAPHRAM
SOMETHING OF