Installing The Stator/Pulse Generator Power; Installation Of The Lid Left Side Of The Casing Of The Engine - Honda 2010 CBX 250 Workshop Manual

CBX250
Apply oil to the thread and to the surface of settlement
of bolt the wheel of the engine. Then, install the washer
special and the bolt. Hold the wheel of the engine,
using the special tool. Then tighten the bolt to the spe-
cified torque.
Special tool:
Flywheel support
TORQUE: 103 N.m (10,3 kg.m)
Install the lid left side of the casing of the engine.

Installing the STATOR/pulse generator power

Place the stator / pulse generator power in the lid left side of
the casing of the engine. Install the hub of rubber in the slot
of the lid left side of the casing of the engine, in accordance
with the illustration. Guided correctly the wiring and install
the screw the pin of the cable. Press the pin against the cap
on the local indicated, in a manner that precludes its
turnaround. Then, tighten. Tighten the bolts from the pulse
generator power together with the pin and the three bolts
stator.
TORQUE:
Bolt from the pulse generator
power
Bolt of fixing the stator
The Screw pin of cables
from the stator
INSTALLATION OF THE LID LEFT SIDE OF THE
CASING OF THE ENGINE
Apply oil to the washers and install in the machinery of
reduction in the boot.
Install the spiral of reduction in the boot.
Install the ears of guide and a new gasket.
07725-0040000
5 N.m (0,5 kg.m)
10 N.m (1,0 kg.m)
10 N.m (1,0 kg.m)
ALTERNATOR
BOLT/WASHER SPECIAL
FLYWHEEL SUPPORT
STATOR
SCREWS
BOLTS
PULSE GENERATOR POWER
SPIRAL OF REDUCTION IN THE
BOOT/WASHERS
GASKET
NUEVA
GUIDE SPIKES
HUB OF RUBBER