Oil Filter; Rotation Of Idling - Honda 2010 CBX 250 Workshop Manual

CBX250

OIL FILTER

Drain the engine oil (page 3-12).
Remove the following components:
– Bolts of the lid of oil filter
– Top of filter of oil and o ring
– Oil Filter
– Spring
Apply motor oil in the new o ring. Install it into the groove on
top of filter of oil.
Install the spring between the tabs of the new oil filter.
Install the filter with the mark OUT-SIDE (external side)
geared toward the outside.
Install the lid of oil filter tightening firmly the two bolts.
Supplying the engine with the oil recommended (page 3-11).
The installation of oil filter to the setback can seri-
ously damage the engine.

ROTATION OF IDLING

d
In the event that is necessary to make services with the
engine running, make sure that the local work is well
ventilated. Never put the engine running in closed areas. The
exhaust containing carbon monoxide poison, which can
cause loss of consciousness and even death. Put the engine
running in a local open, or in a local closed equipped with a
ventilation system and extraction of gas.
NOTE
• Check and adjust the idle only after all other items of
engine maintenance have been inspected and ad-
justed in accordance with the specifications. •Engine
shall be hot for the inspection and adjustment of idle
prove accurate. For this, sufficient ten minutes of
progress with intermediate stops.
The Hot engine and put the transmission in neutral.
Support for the motorcycle in the central support, in a
surface. If necessary, turn the bolt acceleration, with a
view to adjust the idle in accordance with the
specifications.
Idle speed: 1.400 ± 100 rpm.
OIL FILTER/SPRING
TOP OF FILTER/O Ring
MARK
SPRING
"OUT-SIDE"
NUEVO
OIL FILTER
O-RING
BOLT OF ACCELERATION
MAINTENANCE
BOLT
TOP OF
FILTER
BOLTS