System Of Electric Starter - Honda 2010 CBX 250 Workshop Manual

CBX250
DIAGRAM OF THE SYSTEM
SERVICE INFORMATION
INVESTIGATION OF FAULTS
SERVICE INFORMATION
GENERAL INSTRUCTIONS
i
Before services in the starter motor, turn the power switch. Otherwise, the engine can operate suddenly,
causing serious injuries.
The •starter motor can be removed with the motorcycle engine installed in the chassis.
•To inspect the start system, always follow the procedures described in the table of Investigation of Breakdowns (page
18-2).
•A battery with low voltage can be unable to operate the starter motor with fast enough, or to provide the quantity of
needed power to the ignition system. •If the flow of the current is maintained through the starter motor, while the
motorcycle engine is stopped, the starter motor may suffer damage.
•Refer to Section 10 to obtain information in respect of services in the clutch boot.
•Refer to Section 19 to obtain information in respect of the following components: power switch Switch to start Switch
to a standstill Switch of side bracket Switch clutch
SPECIFICATIONS
Over the motor brushes of start
18-0
18-1
18-2
Item
18.
STARTER MOTOR
MAGNETIC SWITCH OF THE STARTER
CLUTCH DIODE
Value
12,5
SYSTEM OF ELECTRIC
STARTER
18-4
18-10
18-11
Unit: mm
Service Limit
8,5