Relay Of Indicators - Honda 2010 CBX 250 Workshop Manual

CBX250
DISMANTLING/Installation
Release the connector 3P breaker of side stand.
Remove the bolt and the switch of side stand. Install
the switch of bracket, aligning the following: the bolt
breaker with the hole in the support the slot on the switch
with the bolt fixing of the spring of return of side stand.
Install and tighten the bolt breaker of bracket.
Connect the connector 3P breaker of side stand.

RELAY OF INDICATORS

DISMANTLING/Installation
Remove the plate deflector right (page 2-3). Fuse (15A)
Remove the connector 3P and relay the indicators.
INSPECTION
Check the following items: State of the battery Bulbs of
the indicator burned or outside of the specification
fuse (15A) Operation of the switches of ignition and
the indicator Connectors loose or connected
incorrectly In case of the components related top are
normal, made the following procedures: Release the
connector 3P relay of indicators. Connect
the terminals of the cables Gray and Black / Brown
connector relay of indicator, using a jumper. Tap
the power switch (ON position) and inspect the lights
of the indicators. In case of the light does
not turn: • Inspect with regard to circuit interrupted in
the electrical wiring.
LIGHTS/INDICATORS/SWITCHES
BOLT
CONNECTOR 3P
SIDESTAND
SWITCH
INDICATOR RELAY
JUMPER