Ignition Switch; Inspection Of The Indicator Of Fuel Level - Honda 2010 CBX 250 Workshop Manual

CBX250
INSPECTION OF THE INDICATOR OF FUEL
LEVEL
Plug the connector 2P (Black) of the sensor of fuel level to the
cabling and move the float from the position of tank empty
until the position of tank full . This will verify the functioning
of the indicator of fuel level. In case of the indicator does not
work properly, check the cabling with regard to circuit inter-
rupted or short. In case of the wiring is normal, replace the
connector of the indicator of fuel level.
INSTALLATION
Check if the o ring is in good condition. Replace, if
necessary.
Install the sensor fuel level in the tank.
i
Be careful not to damage the arm of the float.
Install the nuts and tighten firmly.
Install the fuel tank (page 2-4).

IGNITION SWITCH

INSPECTION
Remove the connector of the light (page 19- 4).
Release the connectors of the ignition switch.
LIGHTS/INDICATORS/SWITCHES
EMPTY
FUEL GAUGE
O-RING
NUT/SCREW
CONNECTORS
FULL
SENSOR OF
FUEL LEVEL
NUT