Installation Of The Crankshaft - Honda 2010 CBX 250 Workshop Manual

CBX250

INSTALLATION OF THE CRANKSHAFT

Clean contact surfaces of the casing of the engine. In-
spect with regard to wear or damage, prior to the assembly.
NOTE
In case of the contact surfaces of the casing of the engine
submit small irregularities or roughness, rectify
with a stone of sharpening with oil.
Attach the flywheel and the crankshaft aligning the
reference marks and the holes in the wheels of flywheel,
according to the illustration. Place the crankshaft and the
flywheel, as a whole, on the left half of the casing of the
engine.
Install the special tools in the crankshaft.
Install the crankshaft, using the special tools.
NOTE
To install the crankshaft, make sure the crank is not
compressed in the edge of the casing of the engine.
Tools:
Collar of assembly to the casing of the engine 07965-VM00100
Axle of assembly to the casing of motor 07965-VM00200
Threaded Adapter
After installing the crankshaft, make sure the reference
marks in the balances of the crankshaft and the flywheel,
either as the holes in the wheels of flywheel are aligned.
Install the transmission and assembling the halves of the
casing of the engine (page 11-8).
ALIGN
07965-VM00300
COLLARÍN DE
ARMADO
CRANKSHAFT/FLYWHEEL
LEFT HALF OF THE CAS-
ING OF
CRANKSHAFT
FLYWHEEL
ALIGN
THREADED Adapter
EJE DE ARMADO
Align
THE ENGINE
12-5