Fault Codes - Gbc Advancedpunch Pro; Fault Codes - High Capacity Stacker (Hcs) - Xerox Versant 80 Press User Manual

Press Problem Solving
Fault Code Cause
140-700 Punch container is near full.

Fault Codes - GBC AdvancedPunch Pro

Fault codes for the GBC AdvancedPunch Pro are displayed on the press User Interface
/ Control Panel.
Fault Code Cause
040-100 Jam is detected in the Advanced-
040-101 Punch Pro.
040-900
040-901
040-300 Front door of the Advanced-
Punch Pro is not closed.
040-940 The punch die set is missing or
not fully installed.
040-941 Punch chip container is missing
or not fully installed.
040-942 Punch chip container is full.
140-700 Punch chip container is near full.

Fault Codes - High Capacity Stacker (HCS)

Note
The press configuration can be installed with one or two stacker modules. If the press
includes two HCS modules, the prefix 049 identifies a fault in the first module, and the
prefix 149 identifies a fault in the second module.
This fault code table lists problems and suggested solutions that apply to the High
Capacity Stacker (HCS).
14-28
Remedy
Empty punch container and then reinstall
it.
Remedy
1. Open AdvancedPunch Pro front
door and look for a paper jam; refer
to Clearing Paper Jams in the Ad-
vancedPunch Pro.
2. Remove any paper jam.
3. Close front door.
Close front door of the AdvancedPunch Pro.
Install punch die set or fully insert it; close
front door.
Install and / or fully insert punch container;
close front door.
Empty punch container and then reinstall
it.
Empty punch container and then reinstall
it.
®
Xerox
®
Versant 80 Press
User Guide