Table of Contents
Advertisement
Tools
LDAP Server/Directory Service Settings
Configure the directory server, authentication method, and search attributes and ranges for
LDAP authentication and the Address Book search by LDAP.
You can check the connection to the server by selecting [Connection Test]. Selecting
[Connection Test] > [LDAP Communication Report] outputs the report that shows the
contents of protocol of the LDAP communication transmitted and received by the machine.
Primary Server Name/Address
Enter the primary server name or IP address.
Note
Primary Server - Port Number
Set the Primary server port number from 1 to 65535.
The default value is 389.
Important
Secondary Server Name/Address
5
Enter the secondary server name or IP address.
Note
Secondary Server - Port Number
Set the secondary server port number from 1 to 65535.
The default value is 389.
Important
Authentication Method
Select a method to perform LDAP authentication from [Direct Authentication] and
[Authentication of User Attributes].
Direct Authentication
User ID and password entered by a user are used for LDAP authentication.
Authentication of User Attributes
The user ID entered is used as an attribute specified in [Attribute of Typed User Name] to
perform a search on the LDAP server. [Attribute of Login User Name] of a user found
through the search is used as the user ID of a job and the owner of a job flow sheet and a
folder.
216
For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to 255.
For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.
Do not use the numbers assigned to the other ports.
For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value 0 to 255.
For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.
Do not use the numbers assigned to the other ports.
Advertisement
Chapters
Table of Contents
