Fuji Xerox DocuCentre-V C2265 Administrator's Manual page 604

Problem Solving
15
604
Error Code
117-311 [Cause] Data Security Kit is not attached correctly.
[Remedy] Insert Data Security Kit into the correct slot.
117-312 [Cause] An error occurred in the machine.
[Remedy] Contact our Customer Support Center.
117-319 [Cause] An error occurred in the machine.
117-320
[Remedy] Switch off the machine power, make sure that the touch screen
117-321
is blank, and then switch on the machine power. If the same
117-322
message is displayed again, contact our Customer Support
Center.
117-323
117-324
117-326 [Cause] An error occurred in the machine.
117-327
[Remedy] Switch off the machine power, make sure that the touch screen
is blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support
Center.
117-329 [Cause] An error occurred in the machine.
117-331
[Remedy] Switch off the machine power, make sure that the touch screen
117-332
is blank, and then switch on the machine power. If the same
117-333
message is displayed again, contact our Customer Support
Center.
117-343 [Cause]
Probable causes are follows.
1) When [Image Log Control] on Tools is invaled and [Enabled]
2) When [Transfer Image Log] is invalid (the hard disk is not
[Remedy] For 1), set other than [Transfer Per Job Basis] for [Log to
Transfer].
For 2), install the hard disk to tha machine, or set [Pause] for
[Logs To Transfer].
117-345 [Cause] An error occurred between the machine and the device
connected.
[Remedy] Switch on the machine power without connecting the device for
EP system, and then set [Login Type] to any option other than
[Login to Remote Accounts] under [Tools] > [Authentication/
Security Settings] > [Authentication].
117-347
[Cause] The life of the component which cannot be replaced is expired.
The machine itself needs to be replaced.
[Remedy] Contact our Customer Support Center.
117-348 [Cause] The unformatted SD card used in the other machine is installed.
117-350
[Remedy] Switch off the machine power, make sure that the touch screen
is blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support
Center.
Cause and Remedy
is set for [Log Transfer] under [Transfer Image Log] , [Transfer
Per Job Basis] is set for [Logs to Transfer].
installed), [Log Transfer] is set to [Enabled].