Fuji Xerox DocuCentre-V C2265 Administrator's Manual page 319

User ID for Login
Set whether or not to make the user ID entry field on the user login screen case-sensitive.
When you select [Case Sensitive], authentication is performed using the User ID as
registered (including upper and lower cases). When you select [Non-Case Sensitive],
authentication is performed with case ignored even if the User ID has both upper and lower
cases.
Important
Do not change the setting while a file is stored for the Private Charge Print. Otherwise, you may encounter
problems, such as being unable to print. Change the setting after the machine prints all the files stored.
Do not select [Case Sensitive] when the machine stores User IDs such as "ABC" and "abc" which are regarded
as the same ID under the setting. If you select [Case Sensitive], it may cause the problem and those IDs may
not be displayed. Before you select the setting, correct those User IDs to distinguish them.
When Smart Card Reader is Connected
Set whether or not to enable user ID authentication when [Login to Local Accounts] is
selected and the smart card reader is connected.
When [Smart Card Login] is selected, user ID authentication cannot be used. When [Smart
Card or Control Panel Login] is selected, both smart card authentication and user ID
authentication can be used.
Account Auto Setup for Card Login
Set whether or not to register new user information when [Login to Local Accounts] is
selected and an unregistered user holds a card over the smart card reader.
When [Disabled] is selected, the machine does not register the user. When [Enabled] is
selected, the machine registers the user automatically.
Note
When [Enabled] is selected, [User Name], [Service Access], and [Add User To Authorization Group] will be
displayed.
Set the user name by selecting [User Name].
When [Service Access] is selected, [Copy], [Fax], [Scan], and [Print] will be displayed. You can set [Feature
Access] and [Change Account Limit] for each item.
When [Add User To Authorization Group] is selected, you can select a user role and an authorization group for
the user.
When [Passcode Entry for Smart Card Login] under [Tools] > [Authentication/ Security Settings] >
[Authentication] > [Passcode Policy] is set to [On], you need to enter the passcode twice for the auto assign.
Guest User
Set whether or not to permit a guest user when [Login to Remote Accounts] is selected. Set
the guest user passcode from 4 to 12 digits.
Note
Access restriction for each service cannot be specified for the guest user.
Use of Smart Card
Set whether or not to use smart card authentication.
Smart Card Link Mode
Set whether or not to require a passcode for smart card authentication when [Login to
Remote Accounts] is selected.
Authentication/Security Settings
319
5