Fuji Xerox DocuCentre-V C2265 Administrator's Manual page 665

Setting Item Item Number
ESCP switch
(Paper feed
position)
(CR feature)
Position
adjustment (Vertical
position
adjustment)
(Horizontal
position
adjustment)
Escape sequence
(Escape
sequence)
(Escape
sequence
character)
Form overlay
Stapling
Bypass Tray -Wait
User
60 Sets the position to start printing at 8.5 mm or 22 mm below the top edge of
paper.
[0](Default): 8.5mm
[1]: 22mm
61 Sets the action to be executed when a CR command is received.
[0](Default): Carriage return
[1]: Carriage return and linefeed
15 Adjusts the printing position vertically or horizontally, and changes the
positions of the margins.
[0](Default): Off
[1-500]: -250 to +250 mm
16
Important
Data outside the printable area is not printed regardless of the adjustment of the
print position. In addition, data moved outside the printable area as a result of
adjusting the print position is not printed.
62 A normal extended command is specified starting with hexadecimal 1BH ESC
as the escape sequence identifying the command, followed by ; (3BH). When
you cannot use a semicolon or ESC code with the host computer, you can use
a special string instead as an escape sequence. This setting specifies whether
or not to enable the escape sequence replacement feature. When enabling,
specify the escape sequence with item 63.
[0](Default): Disabled
[1]: Enabled
Note
For more information on extended commands, contact our Customer Support
Center.
63 To control an extended command with a text code, you must specify an
escape sequence (the first two bytes) of the extended command.Enter two
characters using the keyboard displayed on the screen.
[&%](Default) : 0x21 - 0x7e
64 Constantly performs Form Overlay by selecting a form name (No. 01-64)
registered on the machine.
[0](Default) : Off
[1-64]: No. 1 - No. 64
Important
Since the default value is selected for this feature, this setting is not affected when
an extended commend is received.
Once a form name is selected, it continues to be displayed even if the form is
deleted. When a form name is selected using the up and down arrow keys, it is not
displayed. In this case, the setting is set to "Off".
66 Sets the stapling position.
[0](Default) :Off
[1]: Top left
[2]: Top Double
[3]: Top Right
[4]: Left Double
[5]: Right Double
[6]: Bottom Left
[7]: Bottom Double
[8]: Bottom Right
67 Sets whether to suspend the print processing when feeding paper from the
Bypass Tray. Processing is resumed by a user operation on the machine.
[0]: Off
[1](Default): On
ESC/P-K Emulation
Value
16
665