Fuji Xerox DocuCentre-V C2265 Administrator's Manual page 459

Symptom
The copy is Are the document guides on
misaligned or the document feeder set in
skewed. the correct positions?
Is the paper tray inserted
correctly?
Part of the image Is the paper damp?
is missing on the
copy.
Is folded or wrinkled paper
included in the tray?
Is the document pasted or
folded?
The copy has a Is the enlargement ratio too
stripe pattern. large?
Color shift of Is the color calibration
color copies is incorrect?
poor, resulting in
unsatisfactory
image quality.
Is the machine set where it is
exposed to direct sunlight?
Cause
Load the document correctly, and align the
document guides to the document edges.
Reference
Refer to "Copy" > "Copying Procedure" in the User
Guide.
Firmly push in the tray until it stops to insert it
properly.
Reference
Refer to "Loading Paper" (P.66).
If the paper is damp, the copy image may be
partially missing or unclear. Replace the
paper with a new one.
Reference
Refer to "Loading Paper" (P.66).
Remove the unsuitable paper or replace all of
the paper with a new one.
Reference
Refer to "Loading Paper" (P.66).
The pasted or folded section may not be
laying flat on the document glass. Place a
stack of white sheets on top of the document
to flatten the document against the
document glass.
Vertical stripes may be printed on the copies
depending on the ratio. Adjust the ratio to
eliminate the stripes.
Reference
Refer to "Copy" > "Copy" > "Reduce/Enlarge (Making
Enlarged/Reduced Copies)" in the User Guide.
Execute auto calibration.
Reference
Refer to "Executing Calibration" (P.103).
If the document glass is exposed to strong
light when you turn the machine on or cancel
the Power Saver mode, color shift may occur.
Close the document cover and turn the
machine on, and when the machine becomes
ready to copy or print, turn the machine off
and then on one more time.
Image Quality Trouble
Remedy
459
15