Remote Authentication/Directory Service - Fuji Xerox ApeosPort-V 4020 Administrator's Manual

5 Tools
SMTP AUTH Password
Enter the password for verification purposes at the SMTP server. Up to 64 single-byte
characters are allowed.
Note

Remote Authentication/Directory Service

You can make the settings for the remote authentication server and directory service.
Authentication System Setup
Authentication System
Allows you to select the authentication system from [Kerberos (Windows 2000)], [Kerberos
(Solaris)], [LDAP], [SMB], and [Authentication Agent].
After you change the authentication system, folders and job flow sheets used with the
previous authentication system are not deleted automatically. If these folders or job flow
sheets are no longer needed, delete them from the machine. If the same user IDs are also
used on the new authentication system, folders and job flow sheets can be used by the same
users.
Server Response Time-Out
Set the server time-out response between 1 and 75 seconds in 1 second increments.
5
Search Time-Out
Set the user information search time-out between 1 and 120 seconds in 1 second
increments.
Kerberos Server Settings
Configure the Kerberos Servers 1 to 5.
The settings in [Kerberos Server 1 (Default)] will be the default settings for authentication.
Primary Server Name/Address
Enter the primary server name or IP address.
Note
Primary Server - Port Number
Set the primary server port number from 1 to 65535.
The default value is 88.
Important • Do not use the numbers assigned to the other ports.
Secondary Server Name/Address
Enter the secondary server name or IP address.
Note
Secondary Server - Port Number
Set the secondary server port number in the range from 1 to 65535.
160
• If you do not set the password, leave the text boxes blank and select [Save].
• For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to
255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.
• For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to
255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.