Fuji Xerox DocuCentre-V C2265 Administrator's Manual page 520

Problem Solving
15
520
Error Code
016-779 [Cause] An error occurred during scanned image conversion processing.
[Remedy] Retry scanning. If using large-size paper such as A3 with
[Resolution] set to [600 dpi], specify [Resolution] to [400 dpi] or
lower in [Layout Adjustment]. If the error still is not resolved,
contact our Customer Support Center.
016-780 [Cause] A hard disk error occurred during scanned image conversion
processing.
[Remedy] The hard disk may be defective. To replace the hard disk,
contact our Customer Support Center.
016-781 [Cause] Probable causes are as follows:
1) The mail server cannot be found during e-mail sending (TCP/
2) The machine received an SMTP server error from the mail
[Remedy] 1) Take one of the following measures:
2) Enter the host name using ASCII characters.
Check whether or not ASCII characters are used in [Tools] > [Connectivity
& Network Setup] > [Machine's E-mail Address/Host Name].
016-786 [Cause] When using the Scan feature, the machine could not write the
file to the hard disk.
[Remedy] Take one of the following measures:
016-788
[Cause] Failed to retrieve a file from the Web browser.
[Remedy] Take one of the following measures, and then execute the
operation again:
Cause and Remedy
IP session establishment failed).
server during e-mail sending.
Check whether the network cables are plugged in
securely.
Check whether the IP address of the SMTP server
when an IP address is used for server
specification.
Available ASCII characters are follows:
alphabets
numerals
Switch off the machine power, make sure that the touch
screen is blank, and then switch on the machine power.
Load paper on the paper tray as necessary.
If the error occurs when sending an e-mail, take one of the
following measures:
Lower the resolution.
Reduce the size.
Reduce the number of pages, and divide the job into
several e-mails to send.
Send the job by setting [Color Scanning] to [Black & White].
Reload the browser page.
Restart the browser.
Switch off the machine power, make sure that the touch
screen is blank, and then switch on the machine power.