Fuji Xerox DocuCentre-V C2265 Administrator's Manual page 710

Appendix
Operations during the Power Saver mode
16
710
It takes a few seconds before you can operate the system settings under [Tools] after the
machine exits the Sleep mode.
The <Power Saver> button still lights up when you perform the operations which do not
light up the touch screen such as printing command from a computer.
A message does not appear on the touch screen if you open and close the top cover of
the document feeder when the document feeder is deactivated (such as when the service
to use a scanner is not selected). However, the confirmation message appears on the
touch screen and the <Error> indicator lights up when the document feeder is activated
(exits the Power Saver mode) while the top cover is open.
The machine exits the Power Saver mode when you open the document cover to copy or
scan.
After the machine exits the Power Saver mode, the document feeder and scanner device
are activated after the document cover is opened while the scanner device is
deactivated. However, to make the document detected on the document glass, make
sure that the scanner device in the document glass moves to the detect position for the
document size, and then close the document cover.
After the machine is activated from the Power Saver mode, a message does not appear
on the touch screen if you perform the following operations while the service to be used
for the output device, such as copying and secure printing, is not selected.
- Opening and closing the top cover of the document feeder
- Opening and closing the front cover
- Opening and closing the bottom left cover
- Opening the paper tray
- All the operations including opening and closing the front cover of the finisher, and
pressing the buttons
However, the confirmation message appears and the <Error> indicator lights up when
the machine is activated (exits the Power Saver mode) while each cover or a paper tray is
open.
After the machine exits the Power Saver mode, the value detected before the machine
enters the Power Saver mode is displayed or informed as paper tray status and the
information on the consumables such as the toner remaining amount, status of the drum
cartridge, and paper, if the service used for the output device is not activated.
After the machine exits the Power Saver mode, be careful for the following if you use the
copy feature before you activate the service used for the output device. The information
displayed such as a paper size specified for the paper tray or the remaining amount is
detected before the Power Saver mode. If you change the paper size or remaining
amount during the Power Saver mode, it takes a few seconds for the change to be
updated on the screen.
Exiting the Power Saver mode activates the entire machine when Copy, Simple Copy, or
Stored Programming is set as the default screen on the touch screen.
Exiting the Power Saver mode activates the entire machine when [Paper Tray Attributes
During Loading] is set to [On].
The entire machine exits the Power Saver mode when you press the <Machine Status>
button, enter the System Administration mode, or select the Stored Programming
service.
The machine does not exit the Sleep mode when you use the EP service by EP-BB.