Fuji Xerox DocuCentre-V C2265 Administrator's Manual page 454

Problem Solving
15
454
Symptom
The touch Is the screen brightness too
screen is too low?
dark.
Unable to print, Is a message displayed on
or unable to the touch screen?
copy.
Is the power cord
disconnected from the
machine?
Paper is not fed Is the specified size paper
from Tray 5. loaded in the tray?
Unsatisfactory A probable cause is an
print quality. image defect.
Unable to print Non-standard fonts are
text correctly. used for printing.
(Text is
garbled.)
Unable to insert Did you open a cover or
or remove a turn the machine off during
paper tray. printing?
Unable to copy Is the document glass or
with the the document cover dirty?
specified size.
Is the document a
transparent type such as a
transparency film?
Is the document in the
correct position?
Is the document loaded
correctly?
Cause
Adjust the screen brightness on the
[Screen Brightness] screen.
Reference
Refer to "Adjusting Screen Brightness" (P.41).
Follow the instructions displayed to
resolve the problem.
Switch the main power and power off,
and then firmly plug the power cord into
the connector of the machine and power
outlet. Then switch the main power and
power on.
Reference
Refer to "Product Overview" > "Power Source" in
the User Guide.
Follow the instructions displayed to load
paper of correct size, and then try again.
Reference
Refer to "Loading Paper in Tray 5 (Bypass)" (P.68).
Resolve the problem by referring to
"Image Quality Trouble".
Reference
Refer to "Image Quality Trouble" (P.458).
Check the application or print driver
settings. If PostScript (optional) is being
used, download the required fonts.
Do not forcibly insert or remove the paper
tray. Switch off the power. In a few
seconds, switch on the power. When the
machine is ready to receive data, insert or
remove the paper tray.
Clean the document glass and the
document cover.
Reference
Refer to "Cleaning the Document Cover and
Document Glass" (P.99).
Place the document on the
documentglass, and place a white sheet
on top of the document when copying.
Load the document correctly.
Reference
Refer to "Copy" > "Copying Procedure" in the User
Guide.
Remedy