T.38 Settings; Outgoing/Incoming E-Mail Settings; T.38 Transport Protocol; Udptl Listening Port Number - Fuji Xerox DocuCentre-V C2265 Administrator's Manual

Tools

T.38 Settings

Configure the settings for T.38.

T.38 Transport Protocol

Select T.38 transport protocol from [TCP] or [UDP].
Note

UDPTL Listening Port Number

Set the UDPTL listening port number from 1 to 65535.
Important
TCP Listening Port Number
Set the TCP listening port number from 1 to 65535.
Important
RTP Listening Port Number
5
Set the RTP listening port number from 1 to 65535.
Important
Prioritize IP Packets / Prioritize IP Packets (Ethernet 1), Prioritize IP Packets
(Ethernet 2)
Set the priority of IP packet transmission from 0 to 255.
Note

Outgoing/Incoming E-mail Settings

Set e-mail transmission and reception settings.
212
When you use VoIP gateway manufactured by Cisco Systems, Inc., select [UDP].
Do not use any numbers assigned to other ports.
Do not use any numbers assigned to other ports.
Do not use any numbers assigned to other ports.
The value set varies depending on your environment. Consult your network administrator.
Set the value already specified by the network side. If you set other values, the priority does not change.
(For most of Cisco® routers, speech traffic is set to 184(ef). If you change the value, consult your network
administrator.)
The title of this setting item differs depending on the Ethernet interface configuration: When single Ethernet
interface is used, [Prioritize IP Packets] is displayed. When two Ethernet interfaces are used, [Prioritize IP
Packets (Ethernet 1)] and [Prioritize IP Packets (Ethernet 2)] are displayed.
When any interface names are specified in [Ethernet1 - Network Name] and [Ethernet2 - Network Name], the
specified names are displayed instead of "Ethernet1" and "Ethernet2" of [Prioritize IP Packets (Ethernet 1)]
and [Prioritize IP Packets (Ethernet 2)] respectively.