Fuji Xerox DocuCentre-V C2265 Administrator's Manual page 603

Error Code
116-747 [Cause] The paper margin value is too large for the HP-GL/2 active
coordinates area.
[Remedy] Decrease the paper margin value, and then execute the
operation again.
116-748
[Cause] There is no plot data in the HP-GL/2 print data.
[Remedy] Check the print data.
116-749 [Cause] The job was cancelled because the specified font does not exist.
[Remedy] Install the font, or set the print driver to replace the font.
116-750 [Cause] Banner sheet tray malfunction
[Remedy] Restore the tray to normal condition or change the Banner
sheet tray.
116-751 [Cause] The process has been canceled because the hard disk is full.
[Remedy] Delete stored data in the hard disk. If the error still is not
resolved, split the file and send the job again.
116-752 [Cause] The descriptions of the PDF or XPS printing job ticket have a
problem.
[Remedy] Execute the operation again. If the error still is not resolved,
contact our Customer Support Center.
Note
XPS stands for XML Paper Specification.
116-771 [Cause] The data was automatically modified because it included an
invalid parameter.
116-772
116-773
[Remedy] The printed image may be incomplete. Confirm with the sender
116-774 whether the image has a problem, or ask the sender to send the
data again. When using the Internet Fax Forwarding feature,
116-775
confirm its condition with the e-mail recipient.
116-776
116-777
116-778
116-780 [Cause] There is a problem with the document attached to the received
e-mail.
[Remedy] Check the attached document.
116-790 [Cause] Probable causes are as follows:
1) If the operator cancelled printing a document that was
2) For causes other than 1)
[Remedy] For 1), manually staple the first set of the document. Or, do not
cancel printing of a document that is received using the Store
Fax - Local Folder or Store Internet Fax - Local Folder feature.
For 2), check whether the staple position has been correctly
specified, and try printing again.
117-310 [Cause] An error occurred while scanning a document via WSD.
[Remedy] Switch off the machine power, make sure that the touch screen
is blank, and then switch on the machine power. Execute the
same operation again.
Cause and Remedy
received using the Store Fax - Local Folder or Store Internet
Fax - Local Folder feature: The first set of the document is not
stapled.
No set of the document is stapled.
Error Code
15
603