Fuji Xerox DocuCentre-V C2265 Administrator's Manual page 719

You can switch the FTP transfer mode using CentreWare Internet Services, but cannot
switch the mode per job or per destination FTP server.
Depending on your network environment, operations may not be performed properly
unless the FTP transfer mode is switched from [Passive Mode] to [Active Mode].
When [IP Filtering] is enabled, make sure to switch the FTP transfer mode to [Active
Mode].
In [Passive Mode], the server permits a client to connect to the port for the data transfer
so that the client starts the connection. [Passive Mode] is commonly used and also has
lower security risk than [Active Mode].
In [Active Mode], a client notifies the server of the port number for the data transfer so
that the server starts the connection. [Active Mode] may incur a security risk such as
impersonation by third parties.
In addition, the proper connection may not be available in a firewall environment. In
such a case, select [Passive Mode].
SMB Transfer for Scan to PC
If you use Mac OS X 10.7 Lion, contact our Customer Support Center and ask if your
operating system is supported.
If you use OS X 10.8 Mountain Lion, contact our Customer Support Center and ask if your
operating system is supported.
Store to WSD
Note
WSD stands for Web Services on Devices.
When the WSD scan port is not activated, the [Store to WSD] button is not displayed in
the Services Home screen. Enable the WSD scan port to use the Store to WSD feature on
the machine.
Store to WSD feature requires the scanner driver included as standard in Windows Vista
Service Pack 2 or later. When an appropriate operation system is installed, you can
operate scan using [Windows Fax and Scan] or [From scanner or camera] in [Microsoft
Paint].
[Next Original] is not displayed when using WSD scan.
You cannot execute multiple jobs simultaneously. If you execute a job during the scan
job, the latter job is not accepted.
When using WSD scan, you cannot change layout settings by the machine. Configure the
settings on the computer using the scanner driver included as standard in Windows.
Press [Operate From Computer] to display the standby screen. If the standby screen is
not displayed, a scan job will not be started even when the network computer recognizes
the machine. While the standby screen is displayed, the machine does not execute Auto
Clear or enter the Power Saver mode.
After being scanned, remove the originals and then select [OK] on the [Remove Your
Originals] screen. You cannot execute any operation without selecting [OK].
Store to WSD feature requires the default scanner driver included as standard in
Windows Vista or later. Setting items are different from those for the dedicated scanner
driver.
Notes and Restrictions
719
16