Fuji Xerox DocuCentre-V C2265 Administrator's Manual page 708

Appendix
One-Touch Buttons
The One-Touch buttons (only for fax models) are used to specify an address when sending
faxes, IP faxes, internet faxes, Scan to PC, or E-mail. The buttons cannot be used when you
specify an e-mail address, a shared folder of SMB/FTP, or a server address.
The following two methods are available to assign the address numbers to the One-Touch
buttons.
Assigning to the One-Touch Buttons
You can change the way how address numbers and stored programs are assigned to the
One-Touch buttons. When you have changed the assignment, some One-Touch buttons
that were used for address numbers before may be used for stored programs while other
One-Touch buttons that were used for stored programs before may be used for address
numbers. Be sure that you perform the correct operation.
IC Card Reader (optional)
Printed Time in Force Annotation
The time you specified to print a job, the time at which the print job is started inside the
machine, and the time at which the job is actually printed may not be coincident with one
16
another depending on the machine status and settings or the content of the print job. The
time printed in Force Annotation is the time at which the print job is started inside the
machine.
Stored Programming
708
[Type 1]: Assigns the One-Touch buttons 1 to 52 to the address numbers 0001 to 0052,
and buttons 53 and 54 to the stored programming jobs 1 and 2.
[Type 2]: Assigns the One-Touch buttons 1 to 45 to the address numbers 0001 to 0045,
and buttons 46 to 54 to the stored programming jobs 1 to 9.
Note
[Type 1] is selected by factory default.
Reference
For more information on how to change the number of address numbers assigned, refer to "One-touch Buttons" (P.153).
There are two types of IC Card Reader you can choose: the Embedded IC Card Reader
(optional) and the IC Card Reader for Wing Table (optional).
Installing the IC Card Reader to the machine enhances the authentication function of
the machine. Also, you can restrict the usage of the machine and improve the security
management feature and availability of documents.
The following EP accessories can be simultaneously installed on the machine with the IC
Card Reader.
- Foot Switch
- Dispenser 2
- IC Card Cashier
- Coinkit 8
- Coinkit 9
Note
When you want to install IC Card Cashier, contact our Customer Support Center. Our service representative
performs the installation and configures the settings.
The following features and operations cannot be registered on a stored program.
- Registration and call of a stored program
- EP Diagnostic Request