Error Messages
Fuser Failure, Engine Fuser Low Heat Error, or Engine Fuser Over Heat Error
3-20
Troubleshooting Reference Table
Applicable Parts
Fuser Assembly, PL1.4.1
Switched Mode Power Supply,
PL1.1.29.2
Main Board, PL1.1.19
Troubleshooting Procedure Table
Step Action and Questions
1.
Does the error report Fuser
Failure?
2.
Check the thermistor.
Is the circuit open?
3.
Check the line voltages across the
thermostats.
Are they open?
4.
Is the Fuser getting power?
Wiring and Plug/Jack Map References
"Map 3- SMPS Board" on page 9-6
"Main Drive/Joint Board and Optional
Tray Wiring Diagram" on page 9-15
Yes
No
Go to Step 2.
Go to Step 3.
Replace the Fuser
Replace the Main
(page 7-54).
Board
(page 7-39).
Replace the Fuser
Go to Step 4.
(page 7-54).
Replace the Fuser
Replace the SMPS
(page 7-54).
(page 7-76).
Replace the Main
Board
(page 7-39).
Phaser 3600 Printer Service Manual