Remove Ribbon From [Y] [M] [C] [K] Toner Cartridge - Xerox Phaser 6300 Service Manual

Troubleshooting Procedure Table (Continued)
Step Actions and Questions
2 Check the following for evidence of fault or
damage:
Transfer Roller Assembly, PL5.1.4
CTD (ADC) Sensor, PL5.2.19
3
Check the CTD (ADC) Sensor connection.
Is P/J136 connected to the harness?
4 Replace the CTD (ADC) Sensor
(page 8-71).
Does the error persist?
5 Check all pins on the FSR/ADC Harness
PL5.2.28 for continuity.
1. Disconnect P/J36 and P/J136.
2. Check continuity between J36 <=> J136.
6
Check the CTD (ADC) Sensor signal.
Disconnect P/J136.
Does P136-4 <=> P136-1 = 0 V?

Remove Ribbon from [Y] [M] [C] [K] Toner Cartridge

The printer detected that one of the Toner Cartridge ribbons has not been removed.
Applicable Status Codes:
Code 215:
Remove Ribbon from Cyan Toner Cartridge
Code 216: Remove Ribbon from Magenta Toner Cartridge
Code 217:
Remove Ribbon from Yellow Toner Cartridge
Code 218:
Remove Ribbon from Black Toner Cartridge
Initial Actions:
Remove the Toner Cartridge and ensure that the ribbon tape has been
completely removed.
Inspect the mouth of the toner auger for obstructions or debris.
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Pertinent toner cartridge, PL7.2.8~11
Error Messages and Codes
Yes
Replace the
damaged parts.
Go to Step 4.
Go to Step 5.
Go to Step 6.
Replace the CTD
(ADC) Sensor
(page 8-71).
Wiring and Plug/Jack References
No
Go to Step 3.
Reconnect the
sensor.
Complete.
Replace the FSR/
ADC Harness.
Replace the
Engine Control
Board
(page 8-104).
3-45