Disa Auto Answer - Panasonic DBS 824 Installation Manual

DISA Auto Answer FF2
DISA Auto Answer
Software Version: CPC-S and CPC-M, Version 1 .O and higher
Address: FF2 (Trunk)# ll# (0
or l)#
Description
Use this feature to set a trunk(s) to automatically provide DISA tone upon
connection with an inbound caller. (However, after hearing the DISA tone,
the caller will still have to enter an ID code in order to use DISA.)
If a trunk is set to provide DISA tone, you can limit DISA operation on that
trunk to a certain number of hours each day, using the DISA Start Time and
DISA End Time addresses.
Programming
I
FF2
(1.6/d-8)1$ ll.# (Ocy l,,
Trunk Number:
O=DISA tone is not provided;
CPC-S: l-6
CPC-M: l-8
l=DISA tone is provided.
.
Related'Programming .
Direct Inward System Access (DISA) ID Code: FFl 5# (0000-9999)#
DISA Outbound Call ID Code 1: FFl 6# l# (0000-9999)#
DISA Outbound Call ID Code 2: FFl ## 2# (0000-9999)#
DISA Start Xme: FF2 (Trunk)# 19# (HHMM)#
DISA End Tie: FF2 (Trunk)# 20# (HHMM)#
Notes
Interaction With Caller ID. If your DBS 824 system supports Caller ID, do
not
enable DISA on any trunk using this address. (Caller ID wilI
automatically
enable
or disable DISA to the caller based on the phone number
he is calling from.)
Hardware Requirement For DISA. An MFR card is required for DISA, so
that the system can interpret DTMF tones entered via the DISA connection.
2-8
DES 824-10-400 Issued 3/l/95 __