Transfer Ring Pattern - Panasonic DBS 824 Installation Manual

FFl
Transfer Ring Pattern
Transfer Ring Pattern
Software Version: CPC-S and CPC-M, Version 1 .O and higher
Address: FFl 2# 1# 28# (O-6)#
Description
This program address allows you to choose a distinctive ringing pattern for
transferred calls on all DBS 824 phones. This setting will override the
Extension Ring Pattern (set in address FF3 ExtPort# 38#) when calls are
transferred to the extension.
The ring pattern selected in this address will vary according to the type of
phone (Digital or Analog) connected to the extension port; see table below for
these ring patterns.
Programming
FFl 2# 1 ff 28# (0-6)#
t
Transfer Ring Pattern Number
(Default=O; see table below)
Table 1-2. Transfer ring patterns
Related Programming
Terminal Type: FF3 (ExtPort)# 2#
Extension Ring Pattern: FF3 (ExtPort)# 38#
Notes
Adapter Requirement For Analog Phones. Since the DBS 824 has only
digital extension ports, a Single-Line Telephone Adapter (SLT-A) is required
if analog phones are used. Each SLT-A can support up to four analog phones
(and four corresponding extension ports); see
Section 300~Installation
for
more information.
Issued 3/l/95 DBS 824-10-400 Page1-33