Stop Bit Length (Maintenance Port) - Panasonic DBS 824 Installation Manual

Stop Bit Length
(Maintenance
Port)
FFl
Stop Bit Length (Maintenance Port)
Software Version:
CPCS and CPC-M, Version 1.0 and higher
Address: FFl .2# 9# 4## (l-3)#
Description
This program sets the length of the stopbit parameter for transmitted data
over Maintenance serial port CN2.
Programming
FFl 2# 9## 4## (1.3)#
f
l=l
bit
2=1.5 bits
3=2 bits
Notes
Checking Communications Pmawteters. Be sure to properly set all
communication programming addresses when mckiifying any single address
value. Communication parameters for Maintenance are set with addresses
FF12# !3# l# through #.
l-74
DBS 824- 1 O-400
---
Issued 3/l /95