Table of Contents
Advertisement
Default Program
Settings
Introduction to DBS 824 Pragramming
2. Press [FFl]
("System
Program"
is displayed on line 1;
"SELECT
SUB MODE"
is displayed on line 2).
3. Press 1, #
("SELECT
TIME MODE"
is displayed on line 1; "1
:DATE
2:TIME"
is displayed
on line 2).
4. Press 1, #
("DATE SET MODE"
is displayed on line 1;
"MONTH/DAY/
YEAR"
is displayed on line 2).
5. From the keypad, enter the new date in the following format:
Enter month as MM
Enter date as DD
Enter year as YY.
6. Press # to store the program change.
Then press the [ON/OFF] key to exit
programming
mode; the new date is displayed on all phones with an LCD.
Default Program Settings
The following
table shows the default settings for all DBS 824 program
addresses.
Some of these addresses contain number ranges which are shown
in parentheses.
These are the acceptable ranges for trunk numbers, extension
ports, etc. in a CPC-M configuration
with two 208 Expansion Cards. In the
following chapters of this Programming section, the address explanations will
also show the acceptable number ranges for the CPC-S configuration
with
one 208 Expansion Card.
Table 2.
Default program seliings
Address
Program
Default
:, ::.:. :..:.. .:.:.y.:
FFl
I#
and
FFI
2# I#:
GeneralParameters
FFl 1# l# (MMDDYY)#
1
Day/Date Setting
1
Sun JAN 1
FFl 1#
2#
(HHMM)#
Tie
Setting
I
12:oo
FFl
2#
l# l# (Oor l)#
ml
2#
l# 2# (O-2)#
Call Duration Display
SMDR Start Timer for CO Calls
Displayed
Begins after 5 set
FFl
2#
l#
3#
(Oor l)#
Least Cost Routing (LCR) Access
1
Pooled trunk
1
FFl
2#
_l#
4#
(SSD)##
FJ?l 2# 1# 5# '(0 or l)#
Override Toll Restriction With SSD Numbers
SSD Display Restriction
No TRS override
SSD digits are
diwlaved
Intro-8
DBS 824- 1 O-400
Issued 3/l /95
Advertisement
Chapters
Table of Contents
