Smdr Serial Port Flow Control (Xon / Xoff) - Panasonic DBS 824 Installation Manual

FFl
SMDR Serial Port Flow Control (XON / XOFF)
SMDR Serial Port Flbw Control (XON / XOFF)
Sofhrvare Version: CPC-S and CPC-M, Version 1.6 and higher
Address: FFl 2# 2# 6# (0 or l)#
-
Description
Use this address to determine whether the DBS 824 system will control the
flow of data to the SMDR device connected to serial port CNl.
If "XON/XOFF" is activated in this address, the DBS 824's software will stop
the flow of data when the SMDR device's memory buffer becomes full, and
resume the flow when the buffer empties.
Programming
"XON/XOFF" shodd be deactivated (default setting) if a flow control
mechanism is present elsewhere in the interface (i.e., in the printer, or RTS
and CTS lines). A flow control mechanism should always be present 'in order
to prevent data from being lost during transmission.
FFl 2# 2# 6## (Ogrl)#
t
O=Tums
off
6'XON/XOFF" (824
software
does riot control data flow).
1 =Tums on "XON/xOFF" (824 software
controls data flow).
.
Issued 3/l 195
DBS 824-l O-400
Page l-49