Inbound Ring Pattern - Panasonic DBS 824 Installation Manual

Inbound Ring Pattern FF2
Inbound Ring Pattern
Software Version: CPC-S and CPC-M, Version 1 .O and higher
Address: FF2 (Trunk)# 17# (0-9)#
Description Each CO hunk can assigned a distinctive ring pattern for easy recognition of
the trunk during an incoming ring. Up to 9 different ring patterns are
available.
Programming
FF2 (l-6 or l-8)# 17# (019)#
f
t
Trunk Number:
CPC-S: 1-6
Inbound Ring Pattern
CPC-M: l-8
@efault=O; see the following table)
Table 2-1. Inbound ring p&ems
Notes
I
Address
I 1
Number Ring Patterns For Inbound Trunk Calls
0 Synchronize (the pattern is determined by the C.0)
1
3
sec. on/l sec. off
2 2 sec. on/2 sec. off
3 1 sec. on/l sec. off
4
1 sec. on/2 sec. off
5'
1 sec. on/3 sec. 'off
6 .5 sec. on/.5 sec. off
7 .5 secon/.5 sec. off/.5 sec.on/2.5 sec. off.
8.
.5 sec. ord3.5 sec. off
9
1 sec. on/7 sec. off
Transferred
CauS. This setting does not affecttransferred calls. The ring
pattern for transferred calls can be set in the Transfer Ring Pattern address
(FFl2# l# 28#).
Precedence of Extension Ring Padtern
Se#ing. The ring pattern (if any)
assigned to the extension (FF3 ExtPort# 38# Pattem#) will override this
Inbound Ring Pattern for incoming trunk calls.
2-14
DBS 824-10-400 Issuad 3/l/95