Smdr Start Timer For Co Calls - Panasonic DBS 824 Installation Manual

SMDR Start Timer for CO Calls
FFl
SMDR Start Timer for CO Calls
Software Version: CPC-S and CPC-M, Version 1 .O and
higher
Address: FFl 2# l# 2# (0, 1, or 2)#
Description
This timer determines how long the system waits before starting an SMDR
record for the call (both outgoing and incoming). For example, if the timer is
set to 5 seconds, SMDR recording of call data will begin 5 seconds after an
outgoing number is dialed or 5 seconds after an incoming call is answered.
For outgoing calls, the purpose of this timer is to allow the CO to connect the
call, or the called party to answer, before beginning SMDR timing. For
incoming calls, the purpose of this timer is to limit the number of SMDR
records for incoming calls (e.g., if an incoming call lasts for less than 30
seconds, and this SMDR Start Timer is set for 30 seconds, an SMDR record
will not be generated for that call).
Programming
FFl 2# l# 2# (0, 1, or 2)#
t
O= 5 seconds
1=16 seconds
2=30 seconds
Related
Programming .
SMDR Printing Mode 1 -- Outbound and Inbound: FFl 2# 2# 6##
SMDR Printing Mode 2 -- Long-Distance and Local Calls: FFl 2# 2# 7#
SMDR Report: FF3 (ExtPort)# 14#
Page1-6
DBS 824-10-400 Issued 3/l/95