Panasonic DBS 824 Installation Manual page 409

Terminal Programming
Appendix B
,
Terminal
Programming Through a CO or DISA Trunk
Note: To enter the Terminal Programming mode through a trunk, the DBS
824 must be equipped with an MFR card and an external modem.
To program through a CO or DISA trunk:
1. Dial into the DBS 824 through the trunk.
2. Ask the operator to dial the following command (this will switch the
system to the "Maintenance" mode):
##!J9 xxxx (where "xxxx" is the site's password; system default is "9999")
3. Ask the operator to transfer you to the SLT extension number that is
connected to the modem.
4. After the DBS 824 displays the "Remote Programming" banner screen on
the computer, type
P
then press ENTER.
5. Follow the directions on the screen to access the desired program.
Terminal Programming Commands
Use the following commands to navigate terminal programming:
Table B-l. Terminal programming comma?&
Command Description
-01 Access System parameters
-02
Access Trunk parameters
-03
Access
Extension parameters
-04
Access Ring assignments
-05
Access FF key assignments
-06
Access Name assignments
-07
Access Toll Restriction data
-08
-09
-10
-B
-b
Access Least Cost Routing data
Access Copy mode
Access Speed Dial data
Back to previous address
Back to previous port
-F
-f
Forward to next address
Forward to next
port
-R
Ctrl-z
Return to previous mode
Quit
B-2
DBS 824-10-400 Is&d 3/l/95