How To Enter The Programming Mode - Panasonic DBS 824 Installation Manual

Understanding FF Key Programming Introduction to DBS 824 Programming
:ipure 2.
Phone keys used in DroPrammina mode
CONF: Resets entry
to default setting.
'VOL A: Moves backward to the previous
programming level.
FLASH: Stores your entry and moves
backward (decrements port number in
the same address; or decrements program
address number).
HOLD: Stores your entry and moves
forward (increments port number in
the same address; or increments program
address number).
*:
Stores
your entry and
.
moves backward (decrements
program address number).
' #
:
Stores your entry and
moves forward (increments
program address number).
How to Enter the Programming Mode
From the Attendant Port
. '
Programming can be performed from the attendant display phone. A phone
that is connected to extension port 1 with an extension number of 100 is
automatically an attendant phone. By default, extension port 2 (extension
number 101) is the second attendant phone, although this extension can be
reprogrammed. Up to two other phones (four total) can also be programmed
to be the third and fourth attendant phone. Programming is also possible from
other extensions (see "From a Non-Attendant Port" on page Intro-7).
To enter the programming mode from the attendant phone:
1. Press ON/OFF.
2.
Press PROG.
3. Press the pound sign twice (##).
Intro-6
DBS
824-l O-400
Issued 3/l /95